I need to run debug on an old product. I have the tools and connectors used at the time development was done on it but cannot get the JTAG communication running. I'm using a MSP-FET430UIF (grey box) ...

Hi I want to get an interrupt when a SPI reception finished. My setup is the following. I have an SPI D configured as master with loopback mode. My actual application will be configured as slave but ...

I am trying to implement state machine based tasks in 28027. I referred some programmes given in control suite. I am however not able to go between various tasks A0, A1, A2 etc. What could be the ...

I am configuring a new laptop with TI development tools, using the same products as on an older computer. The older computer has been running CCS version 12.4 and C2000ware version 5.02.00.00 for over ...

I want to add that Sysconfig gives an error that the base has been duplicated when I use two inputs from the same ADC. I expected the base to stay the same for a ...

Hi, in the TIDA-010210-GaN reference design, the isolation module U2 uses UCC14150DWNQ1, and this chip cannot be queried on TI's official website. Is it possible to completely replace UCC14150DWN with ...

I have a situation where 4 of the ADC3664 devices will be used in a design. The devices will operate from the same input clock source and are intended to be synchronous. My question is: can the FPGA ...

I used cascade_radar_object_detect to capture the point cloud data from the 4-cascade 2243 radar and used TFDTP to receive the data. When I set the cascade radar's FRAME_PERIODICITY to 50ms, there was ...

We have encountered a boot up issue with TDA4AL at -40 degree C. The boot up process hanged and cannot be recovered even we try to reset the PMIC power on process. The boot process kept the same ...

I'm currently using the "h264_v4l2m2m" hw encoder to encode video in h264 format on TDA4 with the ffmpeg library and stream it using TCP. The problem I'm facing is that I cannot join the stream in the ...

The customer's PD system uses the PMP41115 solution, and there is a reference design on the TI official website But there are a few issues that need to be confirmed, 1.Should the red X line in the ...

I'm not connected the Battery yet. Trying to power on the board using external power. So, I have powered my device using Type C cable from my laptop. And I got 8.6V in SYS1 & SYS2 pins. This is clear.