when checking the design a couple of question came up on my end. In general my questions are linked to what is really needed to archive SIL 3. Reason for asking this is that we have a space and loss ...

I'm trying to check the temperature in real time by connecting dsp28335 and an external temperature sensor tmp36. I'm trying to see the real time temperature using an ...

I am trying to configure the formatting style in CCS Theia 1.5.1.3. According to https://e2e.ti.com/support/tools/code-composer-studio-group/ccs/f/code-composer ...

"I attempted to import TINAOPAx211.lib and perform a DC analysis with temperature variation in TINA. However, an error occurred during the process. Details are as ...

Based on the " TMDSHSECDOCK-AM263", it is shown the compatible flash/SRAM devices include 256 Mb device. But as per SysConfig tool the address bits available from A0 to A21 (22 bits). To support 256 ...

Customer is using SDFlash for flash writing. The device boots with SCI and assumes that the flash is written via RS232. SDFlash was available in Windows 10, but is no longer available in Windows 11.

What I am trying to do is generate multiple supply rails, a DAC sets the required voltages and the LMH6321's are intended to buffer these voltages and so the load can sink/source up to 200mA. For ...

I can't download my firmware(.out) to CC2745R10 EVB with LP-XDS110 download debugger.(I chose Part number:CC2745P10 because there is no CC2745R10.) Here is a my trouble shooting. 1. Hardware Setup Set ...

PFC工作环境：网侧220V市电输入，380V输出，设备为无线充电设备发射端，UCC28180用作boost pfc供电，设备满载功率为800W，电路可参考下图 问题现象：在设备满功率运行时网侧出现短时低穿，将PFC MOS ...

when VDD goes less than VBOR0- (1.58 v) then BOR is asserted. When VDD goes above VBOR0+ (1.59v) to 1.62 then BOR is released and software is working. As per MCU data sheet. 3) what is the behavior ...

Does MSPM0L1306 support hardware SMI[MDC/MDIO] interface which is used for PHY control? And does TI have the example code for SMI[MDC/MDIO] interface ...

There are questions about the wired-of sinaling described in the app note, that is Wired-Logic Signaling With M-LVDS. 1. In the figure 4, is it no problem to make input pins of multiple devices High ...